Isuzu N Series Camshaft seal replacement
Get quotes for your Isuzu N Series from specialists near you
Australia's #1 booking site for car services & car repairs
Book now, pay later Interest-free payments
Transparent prices no surprises
*Available at select service providers. T&Cs apply.
Isuzu N Series Camshaft seal replacement
Do I need to replace my Isuzu N Series camshaft seal?
If your Isuzu N Series has an internal combustion engine (ICE) then it will have one, two or four camshaft/s located in the engine, depending on the engine type.
Camshafts open and close the intake and exhaust valves. The camshaft is typically located in the top end of a modern engine between the cylinder head and valve cover gasket. It's a long cylindrical rod with irregular shapes or cams on it. The end of the camshaft is driven by gears, a belt or a chain.
Most of the camshaft sits inside the engine but for it to be driven the end of the camshaft needs to project outside of the internals of the engine, this is where leaks can occur as a round rubber oil seal is used to seal around the end of the camshaft. If this deteriorates then oil can leak out of the Isuzu N Series's engine.
When the camshaft seal on your Isuzu N Series starts to leak oil you may notice smoke in the engine bay from oil burning on the exhaust, oil leaking on the ground under the Isuzu N Series or an oil leak below the valve cover.
Oil leaks are never a good thing, you risk smoke inhalation, damage to other components, low oil levels in the engine and subsequent engine damage.
The camshaft seal can wear out over time and begin to leak oil and will need to be replaced when it does. If your Isuzu N Series camshaft seal is leaking, look to AutoGuru for your answers!
