Great Wall Motors MAF sensor clean
Get quotes for your Great Wall Motors from specialists near you
Australia's #1 booking site for car services & car repairs
Book now, pay later Interest-free payments
Transparent prices no surprises
*Available at select service providers. T&Cs apply.
Great Wall Motors MAF sensor clean
Does My Great Wall Motors Need a MAF Sensor Clean?
A Great Wall Motors MAF sensor is situated between the air filter and the intake manifold and uses wires to determine how much air is flowing. It does this by reading how much energy is required to keep one of the wires hot, as air passes. When the Great Wall Motors engine is idling there is less airflow so less energy is needed to keep the wire hot and when there is high airflow, more energy is used to maintain heat in the wire.
If the Great Wall Motors MAF sensor fails and it can’t measure the airflow correctly, the incorrect amount of fuel will be delivered to the injectors. As shown above, this can impact the drivability of the Great Wall Motors and long term can cause engine damage. Great Wall Motors engines don’t like to run lean or rich. It’s good to practise to have the MAF sensor cleaned as part of regular maintenance or when issues arise, for reliability, performance and Great Wall Motors engine longevity.
The cost to clean a MAF sensor will depend on the location of the sensor in the Great Wall Motors and how long the job takes, it might cost around $40 - $100 and if the sensor is damaged or faulty you will need to get it replaced, which will be an additional cost.
