Rover 800 Series Tie rod end replacement
Get quotes for your Rover 800 Series from specialists near you
Australia's #1 booking site for car services & car repairs
Book now, pay later Interest-free payments
Transparent prices no surprises
*Available at select service providers. T&Cs apply.
Rover 800 Series Tie rod end replacement
When do Rover 800 Series tie rod ends need to be replaced?
Your Rover 800 Series will typically have outer and inner tie rod ends as part of the steering system on each side of your car. They are rods with ball joints on each end and they attach to the steering rack on the inner side and to the steering knuckle on the outer side, behind the wheel.
Tie rod ends are responsible for keeping the front end and suspension firm on your Rover 800 Series. When tie rod ends fail, you may notice the steering feels loose.
Tie rod ends can wear out over time, this is usually due to the protective rubber covering getting damaged, which allows dirt and moisture to get in. Because of this, you can’t determine when they may break down. Regular servicing and inspections will help to pick up a failing tie rod end on your Rover 800 Series.
Symptoms your Rover 800 Series tie rod end may be failing:
- Wheel alignment is out
- Vibration or shaking through the steering wheel
- Uneven or extreme tyre edge wear
- Steering feels loose
- Rover 800 Series pulls to one side of the road
- Knocking or clunking noise
- Road wandering
If you continue to drive with a faulty tie rod end, you do run the risk of increased tyre wear and unaligned steering. This can create driver discomfort from road wandering and vibration through the steering wheel.
Worst case scenario would be for the tie rod end to break completely. This would mean no steering, potentially putting you in a very dangerous position.
When your Rover 800 Series needs new tie rod ends, turn to AutoGuru to book the best local mechanic for the job.
