Hyundai Crankshaft rear seal/rear main oil leak replacement
Get quotes for your Hyundai from specialists near you
Australia's #1 booking site for car services & car repairs
Book now, pay later Interest-free payments
Transparent prices no surprises
*Available at select service providers. T&Cs apply.
Average rating for Crankshaft rear seal/rear main oil leak repair
4.5 • based on 2 reviews of 2 businesses
Hyundai Crankshaft rear seal/rear main oil leak replacement
Do Hyundai Crankshaft Rear Seal/Rear Main Oil Leaks Need to Be Repaired?
The crankshaft is the main driving force in an internal combustion engine (ICE). If your Hyundai is an ICE then it will have a crankshaft and rear seals.
At the bottom of your engine, the crankshaft is working with the pistons and connecting rods to harness the energy of combustion. This energy spins the crankshaft, which provides drive to the transmission and down to the wheels.
It sits low inside the engine block, usually just above the oil pan (also known as the sump) and counterweights splash oil to lubricate the main bearings.
Because the transmission and crankshaft pulley is driven by the crankshaft, a front and rear oil seal are needed to separate the inside and outside of the Hyundai's engine.
This seal is usually made up of natural or synthetic rubber and is supplemented by a metal ring on the outside. The seal is held in place by a thin spring which keeps tension on the rubber against the end of the crankshaft.
This keeps the oil in and dirt and debris out. Over time, these seals can perish and start to leak oil. There is no set time replacement interval for these seals, so they need to be replaced when they are leaking.
Time, heat and poor engine oil quality are all factors that contribute to rear main seal failure and once it starts to leak it will need to be replaced. When the seal fails you may notice oil leaking between the engine and transmission, a puddle of oil on the floor/ground and/or low oil level.
A Hyundai
If the engine oil has leaked onto the clutch friction material, it should be replaced to minimise the risk of premature failure. Also, oil leaks can mimic a rear main seal leak, such as a sump gasket leak. The correct diagnosis will prevent unnecessary repairs.
Replacing your crankshaft rear seal as soon as it starts leaking will ensure that your Hyundai is in safe operating condition and less likely to break down unexpectedly.
If the oil level drops due to a leak, excessive damage to the engine can occur, often leading to a full engine rebuild or needing to replace the vehicle. Clutch damage can also occur due to oil contamination.
When your Hyundai crankshaft rear seal develops a leak and needs to be replaced, that’s when your friends from AutoGuru can help!
Hyundai Models
- Hyundai Accent
- Hyundai Accent/Excel
- Hyundai Accent/Pony/Excel
- Hyundai Coupe
- Hyundai Elantra
- Hyundai Excel
- Hyundai Genesis
- Hyundai Getz
- Hyundai Grandeur
- Hyundai HD
- Hyundai i20
- Hyundai i30
- Hyundai i30 Hatchback/Fastback
- Hyundai i30 Sedan
- Hyundai i40
- Hyundai i45
- Hyundai iLoad/iMax
- Hyundai Ioniq
- Hyundai Ioniq 5
- Hyundai Ioniq 6
- Hyundai ix35
- Hyundai Kona
- Hyundai Lantra
- Hyundai Palisade
- Hyundai Pony
- Hyundai S Coupe
- Hyundai Santa Fe
- Hyundai Sonata
- Hyundai Sonata/Sonica
- Hyundai Staria
- Hyundai Staria Load/Van
- Hyundai Terracan
- Hyundai Tiburon
- Hyundai Trajet
- Hyundai Tucson
- Hyundai Veloster
- Hyundai Venue